Allied Vision Technologies F-131C Instruction Manual download pdf (Page 49)

Mako Technical Manual V3.0.0

Camera interfaces

Control signals

The inputs and outputs of the camera can be configured by software. The differ-

ent modes are described below.

Inputs

Input/output pin control

All input and output signals that pass the I/O connector are controlled by the

I/O strobe commands.

Outputs

Output features are configured by software. Any signal can be placed on any

output. The main features of the output signals are described below:

Figure 39: Input block diagram

Signal Description

GPO Configured to be a general purpose output, control is assigned to

SyncOutGpoLevels.

AcquisitionTriggerReady Active once the camera has been recognized by the host PC and is ready to start

acquisition.

FrameTriggerReady Active when the camera is in a state that will accept the next frame trigger.

FrameTrigger Active when an image has been initiated to start. This is a logic trigger

internal to the camera, which is initiated by an external trigger or software

trigger event.

Exposing Exposing – active for the duration of sensor exposure.

FrameReadout Active during frame readout, i.e., the transferring of image data from the CCD

to the camera memory.

Table 26: Output signals

Polarity

selectable

via software

Input state

Input signal

Optocoupler

LP ﬁlter

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 77 78

No comments

Allied Vision Technologies F-131C Instruction Manual Page 49